 |
STEP 1
Identify the inside and outside of the product.
- The inside (side placed against the skin) has a white absorbent layer.
- The outside of the belted shield has a white moisture-proof outer cover.
|
 |
STEP 2
Identify the front and back of the product.
- The front of the belted shield has two angled patches of fuzzy green fabric
on the outside of the top of the belted shield.
- The back of the belted shield also has two patches of the same fuzzy green fabric,
but attached squarely to the top of the belted shield.
|
 |
STEP 3
Attach the elastic straps to the back of the belted shield by pressing
the hook & loop tabs onto the fuzzy green fabric patches. |
 |
STEP 4
Move the person onto his or her side. |
 |
STEP 5
Place the inside of the belted shield (the white absorbent layer)
against the buttocks. Align the end with the elastic straps with the
person's back waistline. |
|
STEP 6
While holding the belted shield in place, roll the person onto his or her
back, so they are centered on top of the belted shield. Bring the front of the
belted shield up between the legs. Make sure that the straps are not twisted and press
the hook & loop tabs onto the fuzzy green fabric patches on the front.
STEP 7
- Position for a close fit by pulling the elastic straps toward the waistline, making
sure heights on the front and back of the belted shield are equal.
- Elastic straps should be angled slightly upward, over the hips.
- Make sure the straps are not twisted.
- Move any folds of skin - especially on the inner thigh - to prevent leaking and chafing.
- Save elastic straps for reuse. To clean elastic straps, hand wash in mild detergent and
hang to dry. DEPEND Belted Shields with EasyFit adjustable strap tabs by VELCRO USA Inc.
packages include two pairs of elastic straps.
- Note for men: be sure that the penis is pointing down into the belted shield.
|
