 |
STEP 1
Identify the inside and outside of the product.
- The inside (side placed against the skin) has a white absorbent layer.
- The outside of the belted shield has a white moisture-proof outer cover.
|
 |
STEP 2
Identify the front and back of the product.
- The front of the belted shield has two angled patches of fuzzy green fabric
on the outside of the top of the belted shield.
- The back of the belted shield also has two patches of the same fuzzy green fabric,
but attached squarely to the top of the belted shield.
|
 |
STEP 3 - without clothing
Attach the elastic straps to the belted shield by pressing the hook & loop
tabs onto the fuzzy green fabric patches located on the front and back of
the belted shield. Make sure that the straps are not twisted. Step into the
belted shield and pull on like underwear. |
 |
STEP 3 - with clothing
If you are already wearing clothes, attach the elastic straps to the back of the
belted shield. Place the belted shield between your legs, then attach the other
end of each strap to the angled patches on the front of the
belted shield. Pull the belted shield on like underwear. |
 |
STEP 4
- Position for a close fit by pulling the elastic straps toward the waistline, making
sure heights on the front and back of the belted shield are equal.
- Elastic straps should be angled slightly upward, over the hips.
- Make sure the straps are not twisted.
- Move any folds of skin - especially on the inner thigh - to prevent leaking and chafing.
- Save elastic straps for reuse. To clean elastic straps, hand wash in mild detergent and
hang to dry. DEPEND Belted Shields with EasyFit adjustable strap tabs by VELCRO USA Inc.
packages include two pairs of elastic straps.
- Note for men: be sure that the penis is pointing down into the belted shield.
|
